Page 13
SYSTEM
Square Back System
5 Maintenance
SERVICE INTERVAL
It is recommended that your SBS is serviced by an
approved Morgana engineer at six to twelve month inter-
vals (depending on usage). Please contact Morgana
for further details.
OPERATOR
MAINTENANCE
As with all machinery, your SBS will benefit from regular
cleaning to prevent build up of dust and general dirt.
• Check that the air vents are not obstructed or
blocked. Obstructed air vents will cause the motor to
overheat.
• Once a week, or as required, clean the carriage
roller as explained below.
• Do not use the SBS on booklets where the ink is still
wet. This may result in ink transfer, and increase the
need for cleaning.
Cleaning the Carriage Roller
1. Set the operating mode to Double Pass, and the
Book Thickness Adjustment to maximum.
2. Take a maximum thickness (6.5mm) A4 size booklet,
and wrap a sheet of paper around the outside. Alter-
natively, take about 30 sheets of A3 80gsm paper
and fold into an A4 size booklet.
3. Apply a thin coating of a suitable cleaning product
(see below) to the spine of the booklet.
4. Hand feed the booklet into the SBS in the normal
way. Re-insert the booklet and reprocess about 5
times.
5. Remove the outer sheet, to give a fresh clean sur-
face, and repeat step 4.
Suitablecleaningproductsincludealcohol (isopropanol),
offset litho blanket wash or RS Solvent Cleaner Aerosol.
Always observe any health and safety information
supplied with cleaning products.
Warning
Cleaning solvents are flammable. DO NOT spray them
directly into the SBS.
USA Users:
6.5mm is ¼”
For A4, use 8½ x 11”
For A3, use 11 x 17”
80gsm is 20# bond
