INTRODUCTION
Page 4
SQUARE BACK
The Automatic Square Back System post-processes stitched or
stapled booklets to give them the professional flat appearance
of a perfect bound book, but with the security of a stitched spine.
The resulting Square Back booklets are flat, making them easy to
stack, handle and pack.
In these instructions the Automatic Square Back System is
referred to as the SBS.
INSTALLATION
Your SBS should be located on a level floor.
If your SBS is used online with other equipment, installation
requires specialist knowledge and should therefore only be
Carried out by a Morgana approved engineer.
Caution
This machine must only be plugged into an electrical
supply line of the correct voltage and with a proven earth.
Anydamage caused by failureto do sowillnotbecovered
by the guarantee. The requiredmachine voltage is shown
on the label on the rear of the unit.
SAFETY
INFORMATION
Your SBS has been designed with safety as a key feature.
However, to ensure it is used safely please observe the
following cautions and warnings:
Warnings
• As with all electrical equipment, disconnect the unit
from the mains electricity supply when replacing
fuses or when instructed to do so in this manual.
• The disconnect device is the appliance inlet.
• Do not attempt to put your hands or objects, other
than booklets, inside the SBS during operation.
• Do not remove machine covers. Only competent and
trained service engineers should service this equipment.
GETTING HELP
We are confident that your SBS will give many years of
trouble-free production. If you have any queries or prob-
lems, in the first instance please refer to the problem
solving section in this book . Should you require further
assistance, the Morgana Service Department will be
happy to help.
