OPERATOR MANUAL BM 60
T10170
22
4.1.4 Block stapling, option 2
1. Open the top cover.
2.
Select Double stapling with the double/single stapling switch.
3.
Adjust the side guides to proper paper size by loosening the side guide screws.
4.
Position the stapler heads above the correct anvils (see table in section 4.1.8).
5.
Load the stapler magazines. By pressing the stapler magazine release button the
magazine will come out.
NOTE:
Use only Chisel point staples P/N 800001.
6. Insert one set.
7.
Make the final adjustment by loosening and moving the right side guide up against the
set and then back 1 mm.
8. Remove the set.
9. Mount the two paper stop pins in the holes. The pins will stop the set in correct posi-
tion (in this mode the set will not be transported through the machine).
10. Close the top cover.
11. Set the stapling switch to
ON
position.
12. Set the folding switch to
OFF
position.
13. Select manual start and set time delay to minimum.
14.
To operate insert one set and press the manual start button. When stapled, remove
set and insert the next one.
Summary of Contents for BM 60
