T10170
OPERATOR MANUAL BM 60
25
4.1.7 Corner stapling horizontal
1. Open the top cover.
2.
With the double/single stapling switch select single stapling.
3. Mount the Corner Stapling Guide
(optional accessory p/n 600003) on the left side
guide and move it as far left as possible.
4.
Set stapler head 1 above the correct anvil (see table in section 4.1.8) Load stapler
magazine, by pressing the stapler magazine release button the magazine will come
out. Make sure the magazine in stapler 2 is empty.
NOTE:
Use only Chisel point staples P/N 800001.
5. Insert one set.
6.
Make the final adjustment by loosening and moving the right side guide up against the
set and then back 1 mm.
7. Remove the set.
8. Mount the two paper stop pins in the holes. The pins will stop the set in correct
position (in this mode the set will not be transported through the machine).
9. Close the top cover.
10. Set the stapling switch to
ON
position.
11. Set the folding switch to
OFF
position.
12. Select manual start and set time delay to minimum.
13.
To operate insert one set and press the manual start button. When stapled, remove
set and insert the next one.
Summary of Contents for BM 60
