Operator Manual
Digibook 300
69
rev. 3.00
Preparation of the machine to produce a book.
CONTROLS TO PERFORM BEFORE STARTING THE JOB
Before to use the Perfect Binder perform the following controls:
The operator must have read and understood this manual, including
the important information concerning the SAFETY.
Make sure you have appropriate clothing to work and, if necessary,
also safety clothing.
Ensure that the Perfect Binder is properly powered and connected
to ground (PE)
Ensure that the pneumatic system of the Perfect Binder is properly
fed and if the main switch oh the factory is open.
Verify that the chips aspirator is connected to the Perfect Binder
and its power switch is in position 1 = ON.
Check that in the tank there is a minimal amount of glue to allow to
process several books, otherwise insert a new cartridge of glue in-
side the tank.
Glue collection tank flushed.
Ensure that the Perfect Binder is clean and without books or covers,
especially: Clamp, Silent Plate, Milling Station, PUR head, Press.
Check that the temperature settings are correct for the used glue
and that have been achieved the correct values to work.
Refer to the technical sheets of the glue/cleaner manufacturer.
Verify that the values of temperatures have reached their work val-
ues.
Both temperature indicators must be lit.
If necessary, remove the layer of Blue-Cleaner from the PUR head.
5500 NE Moore Court
Hillsboro, OR 97124
Toll Free: 1-800-944-4573
Local: 503-640-5920
