Page 15
SYSTEM
Setting the Machine up as a Creaser
LEFT HAND
SIDE GUIDE
FIG 13.1
RIGHT HAND
SIDE GUIDE
LEFT HAND
BACK STOP
RIGHT HAND
BACK STOP
Setting the Stacker assembly
The stacker unit on the machine is used to catch the sheets once they have been
creased or perforated.
NOTE:- This stacker unit is not fitted when the machine is being used as a Booklet maker.
1. Assemble the stacker unit to the machine as shown in fig 13.1 below.
There are two side guides on the stacker unit; a left handed guide and a right handed
guide. The guides will control the way in which the paper is collated by setting their
positions on the stacker bed.
2. Place a single sheet (from the stack to be creased / perforated) on to the stacker bed
against the ‘left hand’ guide.
3. Position the ‘right hand’ side guide on to the stacker bed leaving a minimum
clearance of approximately 1mm each side of the sheet.
Important
Ensure that the stacker unit has been assembled to the machine properly. However,
if it has not, the connection on the magnetic switch will be broken and the machine
will not operate (see Trouble shooting pages for details).
DocuMaster MK3
