Page 19
SYSTEM
Setting the Machine up as a Creaser
Back
Tens
Decimals
2nd Crease
0.0
( 1st Crease
297.0 )
Set Creases
Back
Tens
Decimals
3rd Crease
0.0
( 2nd Crease
0.0 )
Set Creases
Batch 20
Total 80
No Program
Reset
Setup
Tools
Feed
2 Creases
Autocreaser
(iv) Move the selection switch to the left to select Tens, or to the right to select Decimals.
(v) The Tens or Decimals (whichever has been selected) can then be adjusted by
rotating the Selection Switch, (clockwise to increase or anti-clockwise to decrease).
(vi) Adjust all other digits for the 1st Crease position as described in steps (iv) and (v),
(i.e. move the selection switch to the left to select the Tens or to the right to select
Decimals and then rotate the Selection Switch to adjust its value.
(vii) To set the 2nd Crease position move the selection switch down; the 2nd crease is
selected and can be set as described in steps (iv) to (vi) above.
Crease positions can be set in increments of 0.1mm. Further creases can be set in
this way, up to a maximum of nine creases.
(viii) When the required creases have been set, move the selection switch up, one click
at a time, until the display contains the word
, see below.
6.
Once the crease positions are correctly entered, they can be stored as follows.
(i) Move the selection switch to the right to select
.
(ii) Move the selection switch to the right, one click at a time, (selecting
) until the
display contains the word
.
(iii) Move the selection switch down to select
(iv) Rotate the Selection Switch to select the Program number (1 to 9).
(v) Move the selection switch to the right to select
.
(vi) Move the selection switch to the left to select
or to the right to select
Feed
Setup
More
Programs
Save Settings.
Select
Yes
No.
Storing the crease positions
DocuMaster MK3
