Page 20
CREASING / BOOKLET MAKING
Setting the Machine up as a Creaser
Running the machine
In order to manually feed sheets see instructions below.
Reading stored programs
Paper jamming
Setting the machine to operate in manual mode
7. To run the job with the selected settings.
(i) Press the Compressor Switch down.
(ii) Press the System Switch down.
(iii) Move the selection switch down to begin feeding the sheets.
To stop feeding the media at anytime during the program, flick the selection switch up.
The machine will complete its creasing operation if a sheet has already been fed
through the paper gate.
Any of the nine stored programs can be accessed and read as follows:-
(i) From the start up menu, move the selection switch to the right to select
.
(ii) Move the selection switch to the right, one click at a time, until the display contains
the word
.
(iii) Move the selection switch down to select,
.
(iv) Move the selection switch to the right to select,
.
(v) Rotate the selection switch clockwise or anti-clockwise to select,
to
and view the program settings.
In the event of a paper jam occurring whilst the machine is operating the display will
read
In order to remove the paper causing the jam, move the selection switch
to the left or to the right to drive the paper forwards or backwards in short pulses.
In order to feed heavy stock, very small or very large sheets, embossed or even
irregular shaped sheets, it may be required to operate the machine manually.
The machine can be programmed and set up in exactly the same way as explained
when operating the machine automatically. However, when setting up the machine the
paper gate must be raised to its highest position for the sheets to be fed freely.
Operating the machine manually will also require the suction length to be continuous in
order to accommodate various types of stock. Therefore, the feed should be set to
see page 17.
The machine can now be started by activating the System switch to ‘on’.
Move the selection switch down to select
and
begin to slide the sheets individually through the paper gate until they are driven by the
drive belts. To stop feeding the sheets, move the selection switch up and then the System
Switch up.
Setup
Programs
Retrieve Program
Select
Program 1
Program 9
Paper Jam.
Long Pulse
Do not
activate the Compressor switch.
Feed
