Page 38
CREASING / BOOKLET MAKING
Variable Data
Prog ?
Books ?
Reset
Setup
Tools
Feed
Image Rec On
Leading Edge
Crease
90mm
+70 mm No Hinge
Image Can Only Be
Within This Band
Of Sheet
+60 mm 10 mm Hinge
-20 mm No Hinge
-30 mm 10 mm Hinge
If
is Selected
Cover
If
is Selected
Sheet 2
Image Can Only Be
Within This Band
VARIABLE DATA
1. Programme the machine for Booklet Maker operation as described on
pages 22 to 32, setting the
to
as described
on page 25.
2. Operate the Camera Recognition System as described on pages 34 to 36.
When the selection switch is moved up until the display contains the word
the display will read as shown below.
3. Load the booklet stack onto the feed bed; and then run the job by switching
.
the Compressor and System Switches on, and then move the selection
switch down to select
.
Sheets in Book
Variable Data
Limitations of the position of the Image, to be captured, on the sheet.
Feed
NOTE:-
NOTE:-
The default position, (of the image capture position), from the leading edge of
the sheet is 90mm. If there is no image on the sheet, at 90mm from the leading
edge of the sheet, then another position greater than 90mm must be set.
Limitations to the positions of the captured image are pre set in the software
and cannot be exceeded. See Below.
Feed
