Page 48
Trouble Shooting
CREASING / BOOKLET MAKING
Recommended weekly operator maintenance
Technician Maintenance
• Clean all sensors
• Clean in feed rollers and output drive hubs using the cleaning kit supplied.
(Cleaning kit part number 90-018)
• Remove and clean the blade assembly
• With the blade assembly removed, clean the slots and surrounding area
within the creasing unit.
It is recommended that your machine is fully serviced at least once every six months
by a factory trained Service Engineer.
To
To
Re-register the Booklet Maker Unit.
Reset The Booklet Maker Unit Back To Factory Default Settings.
NOTE:-
The Booklet Maker Unit can be re-registered as follows:-
This function will adjust all motor settings to a known start position. It will also display the
version of software loaded into the Interface Module (housed within the motorised infeed unit),
and the version of software fitted on the Main Control board of the Booklet Maker Unit.
This will reset the Booklet Maker Unit back to default factory settings and should only be used
as a last resort.
1. From the Booklet Maker start up menu, move the Selection Switch to the left to select
.
2. Move the Selection Switch down to select
.
3. Move the Selection Switch to the right to select.
1. From the Booklet Maker start up menu, select move the Selection Switch to the left to
.
2. Move the Selection Switch down to select
3. Move the Selection Switch to the right to select.
Minor sideways misalignment, caused by uneven floor or machine build tolerances, can be
adjusted as follows:-
1. From the Booklet Maker start up menu, move the Selection Switch to the left to select
.
2. Move the Selection Switch down to select
.
3. Rotate the Selection Switch to adjust, a positive value will move the Creaser Unit away
from the operator.
Values of less than 3 may not be enough to adjust the position.
Tools
Re-register BMP
Tools
Set BMP ‘DEF’.
Tools
BMP Alignment
To Adjust Misalignment Between Creaser Unit and Booklet Maker Unit.
