Morgana KB2000, Operator'S Manual

Paper Sensor in clamp assy 

In paper clamp station prevents clamping 
without paper to be bound positioned 
between the clamps. Place paper to be 
bound close onto back side of clamp. 
Keep the sensor clean from paper dust. 

Clamp Opening Stop... 

…is factory-set to widest position. In case 
of serial binding procedure of books with 
substantial smaller spine it is 
recommended to set the bolt in front more 
close to minimize the opening of clamp. A 
hexagon screw is fixing the bolt. (A driver is 
included in accessory package). 
Limiting the clamp opening in acc.to spine 
of books enables the operator for easier 
loading of paper-sets into clamp assy.  

Cover for Slitting/Fanning Device 
Is covered by a sliding coverage whilst clamp 
is in right position. It opens whilst clamp is 
moving across and it closed shortly after by 
pass of clamp. It only is allowed to disengage 
cover-system by authorized service. 
The cover system prevents accidents for 
operator

.

  Open                                  Closed    

 
 
 
 
 
 
7) Taking in account and make use of all safety devices it is possible to 

change the glue. 

     The reason might be the choice of another type of glue. Never mix up different types of glue! 
     The factory filled glue can be ordered from supplier.   
     In case of a wrong set up of temperature for the type of glue in tank the glue might “burn out”.     
     After very long time of heating without using glue for binding the glue might be overheated. 
     In both cases the glue must be changed. (Glue only can be changed in melted condition!) 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 

Outlet of Glue-Tank 

Place card board box under shut 
of outlet. (Steel can might become 
hot – plastic can might melt!) 
 
A 10 mm hexagon screw driver is 
supplied with the accessory 
package for opening the outlet 
lock screw. 

Release melted  glue in card board box.                               
( Not included in accessory-package.( Use any one.) 

Slitting/Fanning-Device is designed that only the upstanding 2 knifes are slitting and bending 

the edge of slit! The “round type of saw “must never touch the spine of book!!! The setting is 
exactly of level spine for fanning the edges of paper! Function is not scuffing at all!