Deflect
Stacking Roller
Emergency Stop Switch (S)
Main Switch (T)
Feed Switch (U)
Batch Knob (V)
The second (short) fold plate has the ability to be shut off into a deflect position to enable
single folds to be achieved without removing the fold plate from the machine. To set the plate
to deflect, first ensure that the tilt is set at zero, then after releasing the lock knob (H), keep
winding the dial (J) to minimum length until it stops, then tighten the lock (H). The digital
plate will show a series of dashes --- in the window.
The stacking roller must be set according to the length of the folded work. The roller is moved
by releasing knob (P) while sliding the block Q to the required position. You should adjust the
roller position so that when the work is stopped by the stacking roller, it lies flat on the delivery
without lying on the sloping plate (R) and without the green belts showing between the sloping
plate (R) and the folded sheet.
This switch also serves as the main isolator and when the machine is switched off at the end of
the days running, press this switch to isolate the machine. To switch back on, rotate the switch
head clockwise.
The main switch (T) will run the whole machine. This switch incorporates a circuit that
switches off every 100 seconds whilst the feed switch U is in the off position. The main switch
may disengage seemingly at random but this is a normal function and may be instantly re-
engaged.
Switches the feed on and off.
The batch knob is a rotary switch and turning the knob slightly so that it moves one position
will cause the display to show the set batch quantity. Moving the knob further will change the
batch quantity in multiples of 10 up to 990. Stopping the feed in the middle of a batch will not
affect the batch. When the machine batches, the feed will stop and the display will show the
batch quantity with a series of dashes. Feeding will resume after a short period. If batching is
not required, turn the batch knob (V) until it reads 0 in the display panel. When 0 is shown
after turning batch knob (V) the counter will only total count.
Page 14
PAPER
Summary of Contents for Major
Page 7: ...Page 7 FOLDER Major BLANK PAGE ...
Page 19: ...Major Page 19 FOLDER ...
