Type A
Part No.6-99-05P
Standard
Type B
Part No.6-99-06P
Heavy Duty
Type C
Part No.6-99-07P
Special
Type D
Part No.6-99-08P
Pencil
A square section scorer which will produce a light score on
most card.
It should be set centrally between the faces of two perforator
hubs set approximately 1mm or 3/64 inch apart.
A square section scorer which is suitable for use on heavy
card.
It should be set centrally between the faces of two perforator
hubs set approximately 2.5mm or 3/32 inch apart.
This is for scoring particularly hard materials, or if shaft
deflection causes a problem when producing more than one
score line simultaneously.
It is a square section scorer, only available to special order
and should be set centrally between the faces of two
perforator hubs set approximately 3mm or 1/8 inch apart.
A pencil scorer ideally suited to provide a pre-folding score
on paper and is set centrally between the faces of two
perforator hubs set approximately 2mm or 1/16 inch apart.
The settings described above are for guidance only and are generally intended as a
starting point. The exact positions should be found during makeready to give
optimum results with the stock being used.
7.7
Operating
17
Having first set up the perforating, scoring wheels (if required) the
'Swing- up Perforating Unit' may be raised into its operating position (as
shown below).
To release the 'Swing-up Perforating Unit', back into the folding position,
push the two black knobs (V) inwards (as shown); and lower the unit
carefully to the horizontal position.
V
V
Swing-up Perforating Unit
