MANUAL OPERATION B-11
3-2
Reset Key
The procedures for stopping the machine with the
(RESET) key and clearing the reset status
are described here.
1)
Press the
(RESET) key.
When the
(RESET) key is pressed during automatic operation, the spindle rotation and
axis movement stop.
At the same time, the NC is placed in the reset status.
When the
(RESET) key has been pressed to stop the machine during a threading
operation or a hole machining operation, especially a tapping operation (M type),
carefully move the axes after checking the workpiece and cutting tool carefully for
damage. If you move the axes without due care, the workpiece and cutting tool may
collide or interfere with each other, and this could damage the machine.
<To restart operation>
1)
Select the memory mode (
) with the mode
selection switch.
2)
The PROGRAM (memory) screen is displayed.
3)
Locate the head of the program.
The cursor moves to the head of the program.
4)
Close the front door.
5)
Carry out the zero return operation.
WARNING
To restart the program from a required block after resetting the NC, check
the status of the machine and that of the NC and specify the M, S, T, G, and
F codes, the work coordinate system, and other necessary information
after selecting the MDI mode. If operation is restarted without specifying
these data, the machine will operate unexpectedly causing serious
injuries or damage to the machine.
CAUTION
MEM
MDI
TAPE
EDIT
H
JOG
RPD
ZRN
MEM
MDI
TAPE
EDIT
H
JOG
RPD
ZRN
