B-76 MANUAL OPERATION
17-1-2
Adjusting the Work Rest (without the Workpiece Unloading Function)
Adjust the work rest position by following the procedure described below.
<Procedure>
1)
Extend the work rest with no workpiece on it.
•
Use the WORK REST MANUAL OPERATION screen for the spindle-side work rest
OUT operation.
•
Specify the T code for the tailstock-side work rest indexing.
Refer to the programming manual provided separately.
2)
Retract the spindle-side work rest and the tailstock-side work rest to a position where they
will not interfere with the workpiece.
•
To retract the spindle-side work rest, loosen the screws for adjustment in the X-/Y-/Z-
direction on the work rest.
•
To retract the tailstock-side work rest, move the axis in the X positive direction in
handle feed operation.
3)
Hold the workpiece with the chuck and the tailstock.
4)
Adjust the spindle-side work rest position (X-/Y-/Z- direction).
Loosen the hexagon socket head cap screws on the spindle-side work rest and adjust the
position in each direction.
Screws for adjustment in the
X-axis direction
Screws for adjustment in the
Y-axis direction
Screws for adjustment in the Z-axis direction
