MANUAL OPERATION B-81
If the center moves out of the range indicated by the arrow A, there is a danger that it will
interfere with the workpiece end face the next time an attempt is made to hold a
workpiece.
5)
Adjust the position of the jig for pulling out the workpiece.
a)
Z -, and X- axis direction: Adjust the position by handle feed operation.
b)
Y-axis direction:
Loosen the screw for adjustment in the Y-axis direction and
adjust the position.
Following the same method as in step 4), adjust the clearance between the work rest and
the workpiece so that the center comes within the center hole range.
6)
Retract the jig for pulling out the workpiece to a safe position.
Retract the work rest to the X positive direction by handle feed operation. If necessary,
retract the work rest in the Z-axis direction.
7)
Stow away the work rest.
Work rest
Workpiece
Clearance
Tailstock spindle
Workpiece
Center hole
Center
Spindle
A
NOTE
Screws for adjustment in the Y-axis direction
