-20- FOR SAFE OPERATION
SO-NL-B17E/O
WARNING
12.
For the machine with the flat type operation panel, always place the
operation selection key-switch in the "operation enable" or
"operation disable" position after completing program entry.
Be aware that the program will be updated if program editing
operations are carried out with the operation selection key-switch at
the "operation and edit enable" position. If the program is executed
after being accidentally updated in this way the machine could
operate unexpectedly, causing serious injuries or damage to the
machine.
13.
For the machine with the discrete type operation panel, always place
the edit enable key-switch in the "edit disable" position after
completing program entry. Be aware that the program will be
updated if program editing operations are carried out with the edit
enable key-switch at the "edit enable" position. If the program is
executed after being accidentally updated in this way the machine
could operate unexpectedly, causing serious injuries or damage to
the machine.
14.
For the machine with the touch panel, always return the WRITE
PROTECT switch (PROGRAM) back to ON after completing program
entry. Be aware that the program will be updated if program editing
operations are carried out with the WRITE PROTECT switch
(PROGRAM) set OFF. If the program is executed after being
accidentally updated in this way, the machine could operate
unexpectedly, causing serious injuries or damage to the machine.
15.
Workpiece materials and shapes vary widely among machine users.
Mori Seiki cannot predict the workpiece clamping method, spindle
speed, feedrate, depth of cut, and width of cut, etc., that will be
required in each case and it is therefore the user's responsibility to
determine the appropriate settings.
Note also that the machining conditions determined in automatic
programming are the standard conditions, which are not necessarily
the most suitable for the user's purposes and may have to be
changed in accordance with the workpiece, chuck, etc. The
conditions determined in automatic programming are for reference
only and the final responsibility for determining the conditions rests
with the user. (Conversational NC specification)
If you have difficulty determining these conditions, consult the
chuck and cylinder manufacturers and tool manufacturer.
Machining under inappropriate machining conditions can cause the
workpiece to fly out of the chuck during machining, causing serious
injuries or damage to the machine. It will also adversely affect
machining accuracy.
