CHUCKING C-15
18)
Machine the jaws that clamp the plug.
Shaping the jaws to "plug di Max. jaw
stroke
×
1/2" allows the plug to be clamped at the
center of jaw stroke.
19)
With the manual door type machine, press the
DOOR UNLOCK switch
to unlock the front
door. Then open the front door.
With the automatic door type machine, open the
front door by pressing the AUTOMATIC DOOR
OPEN switch.
20)
Chuck the plug.
When chucking the plug for shaping the soft
jaws, exercise due care to ensure that your
fingers will not get trapped.
Fit the plug on the chuck so that it is not tilted.
21)
Close the front door.
22)
Set the chuck clamping direction to the O.D.
chucking on the OPERATION PANEL screen.
23)
Set "VALID" for CHUCK STROKE END (chuck jaw
stroke end detection function) using the cursor
control keys.
The status indicator
[CHCL]
is lit.
24)
Check for interference by following steps 13) to 15).
25)
After making sure that the spindle can be rotated
without interference, close the front door.
WARNING
It is dangerous to clamp a workpiece
in the chuck with the jaws moved
close to the stroke end.
Shape the jaws so that the plug can
be clamped within proper jaw stroke
range.
DOOR
UNLOCK
NOTE
CAUTION
NOTE
