PREPARATION BEFORE STARTING MASS PRODUCTION E-17
22)
Check the distance between the tools and the
distance between the tool or the fixture to the chuck
using a scale.
Measure the distance for all the tools to check for
possible interference.
When automatic operation has been
suspended and the manual mode selected,
never move an axis or index the turret
manually. If it is necessary to manually move
an axis or index the turret, return the axis or
the turret to the previous position before
restarting the no-load running of the program.
If the no-load running is restarted after
indexing other tool or without returning to the
previous position, a tool may strike the chuck
or other problems may occur, causing damage
to the machine.
23)
If the measured clearance is appropriate and there
is no possibility of interference, close the front door.
24)
Select the memory mode (
) with the mode
selection switch.
25)
Press the
(START) switch.
The program restarts.
NOTE
CAUTION
MEM
MDI
TAPE
EDIT
H
JOG
RPD
ZRN
CYCLE
START
STOP
