E-22 PREPARATION BEFORE STARTING MASS PRODUCTION
24)
Measure the distance between the tool and the
workpiece. Also measure the distance between
adjacent tools and the distance between the fixture
and the chuck.
Measure the distance for all the tools to check for
possible interference.
When automatic operation has been
suspended and the manual mode selected,
never move an axis or index the turret
manually. If it is necessary to manually move
an axis or index the turret, return the axis or
the turret to the previous position before
restarting the program. If the program is
restarted after indexing other tool or without
returning to the previous position, a tool may
strike the chuck or other problems may occur,
causing damage to the machine.
25)
If the measured clearance is appropriate and there
is no possibility of interference, close the front door.
26)
Select the memory mode (
) with the mode
selection switch.
27)
Press the
(START) switch.
The spindle starts rotating at a speed selected
before stopping.
28)
Press the
(START) switch again.
The program restarts.
29)
If there are no problems found in the restarted
program, reset the shift data to its original value
after the completion of the program.
If the INPUT key is pressed, the value having
been input with data entry keys is input for the
work shift offset data (Z-axis). Therefore, make
sure to press the
[+ INPUT]
soft-key.
NOTE
CAUTION
MEM
MDI
TAPE
EDIT
H
JOG
RPD
ZRN
CYCLE
START
STOP
NOTE
