E-30 PREPARATION BEFORE STARTING MASS PRODUCTION
6)
Remove chips from the workpiece using a proper hand tool.
1.
Never touch chips or the cutting edges of tools with your bare hands since you
may be injured.
2.
Never move the axes or rotate the turret head manually. If it becomes necessary
to do these manually, always return the axes or the turret to the previously
located position before restarting the program.
If the program is restarted from a position, different from the previously located
position, an interference will occur between the tool and the workpiece or
between the tool and the chuck causing damage to the machine.
7)
For center-work operation, move the tailstock spindle OUT to hold the workpiece.
8)
Close the front door.
9)
Select the memory mode (
) with the mode selection switch.
10)
Press the
(START) switch.
The spindle starts rotating at a speed selected before stopping.
11)
Press the
(START) switch again.
The program is restarted.
CAUTION