A-28 OPERATION PANELS
<When the spindle OFF mode function is invalid>
When the spindle OFF mode function is made invalid, the dry run function also becomes invalid
and the indicator above the
(STOP) switch and the indicator in the dry run switch
go off.
In this state, normal operation is possible.
5-6-6
Chuck Clamp Direction
This setting is used to indicate whether the chuck clamp is made for O.D. or I.D. of the workpiece
according to the shape of workpiece and the portion to be machined. Chuck clamp operation is
completed when the chuck is operated in the set chuck clamp direction correctly.
It is set as O.D. or I.D. on the OPERATION PANEL screen.
Function selection key
(CUSTOM1)
[OPE. PANEL]
1.
For chuck 2, page 2 of the OPERATION PANEL screen is used to the selection of
clamp direction. (S type)
2.
Do not change the chucking direction while the spindle is rotating.
<When O.D. is selected>
When O.D. is selected for the chuck clamp direction, the status indicator
[CHCL]
is lit when the
chuck clamps the workpiece on its periphery. Spindle rotation is permitted in this state.
<When I.D. is selected>
When I.D. is selected for the chuck clamp direction, the status indicator
[CHCL]
is lit when the
chuck clamps the workpiece from the inside. Spindle rotation is permitted in this state.
WARNING
The machine has a chuck interlock function that prevents starting of the
spindle unless the status indicator [CHCL] is lit. Make sure this interlock
function works correctly by setting the correct chuck clamping direction
for the type of workpiece to be machined.
If the spindle starts rotating while the workpiece is not correctly clamped
in the chuck, the workpiece could fly out, causing serious injuries or
damage to the machine.
NOTE
