MANUAL OPERATION B-5
2-2
Turning On the Power
The method for turning on the power to the machine is described here.
1)
If power is not supplied, turn on the main breaker on
the shop power distribution board.
2)
If the machine uses pneumatically-actuated
equipment, turn on the compressed air.
3)
If the machine uses pneumatically-actuated
equipment, check the pressure of the compressed
air.
Setting pressure varies according to the machine
model and specifications.
For details, refer to the MAINTENANCE
INFORMATION.
4)
Turn on the main switch.
5)
Check the main pressure of the hydraulic unit with
the pressure gage in the main hydraulic line.
For the procedure used for setting the main
pressure, refer to the MAINTENANCE
MANUAL.
6)
Make sure that the cooling fans in the operation
panel, the NC unit, and the electrical cabinet are
operating properly.
7)
Pull out all the EMERGENCY STOP buttons to reset
the emergency stop state.
If the machine has more than one emergency stop
button, it is necessary to pull out all the
EMERGENCY STOP buttons from the pushed
and locked position to reset the emergency state.
WARNING
When the main switch is locked with a
padlock it means that maintenance is
in progress, so do not place the main
switch in the ON position.
2)
1)
NOTE
NOTE
