B-24 MANUAL OPERATION
6-4
Handle Feed Operation
In the manual operation, each axis is fed at the set feedrate using the manual pulse generator.
Handle feed operation is used when machining a soft jaw, removing the rough surface of a
workpiece, or performing a fine positioning adjustment.
1)
Place the DOOR INTERLOCK key-switch in the
NORMAL
position.
2)
Close the front door.
3)
Place the PANEL key-switch in one of the positions
indicated below.
(ON)
(PANEL/EDIT)
4)
Press the head selection switch
(head 1) or
(head 2) to select the required turret.
5)
Select the handle mode (
) with the mode
selection switch.
6)
Select the axis to be fed with the axis selection
switch.
7)
Set the feed amount per pulse using the axis feed
amount selection switch.
The numbers indicate the multiplication of the
smallest increment (0.001 mm).
Feed amount per pulse:
[
×
1]
0.001 mm
[
×
10]
0.01 mm
[
×
100]
0.1 mm
DOOR INTERLOCK
NORMAL
RELEASE
ON
PANEL
/EDIT
OFF
PANEL
1
2
MEM
MDI
TAPE
EDIT
H
JOG
RPD
ZRN
×
1
×
10
×
100
