MANUAL OPERATION B-35
7-5
Spindle Jog Operation
In the manual mode, the spindle can be rotated at the jog feedrate.
Spindle jog operation is possible regardless of the open/closed state of the chuck and the front
door.
The spindle jog operation is used to check the run-out of the chuck jaws and workpieces clamped
in the chuck.
1)
Place the DOOR INTERLOCK key-switch in the
NORMAL
position.
2)
Close the front door.
3)
Place the PANEL key-switch in one of the positions
indicated below.
(ON)
(PANEL/EDIT)
4)
Press the HEAD CHANGE switch
(head 1) or
(head 2) to select the spindle to be rotated. (S
type)
5)
Press the
(SPJ) switch.
The spindle starts in the normal direction at the jog
feedrate.
6)
Release the
(SPJ) switch to stop the spindle.
DOOR INTERLOCK
NORMAL
RELEASE
ON
PANEL
/EDIT
OFF
PANEL
1
2
1
2
NOR
SPJ
REV
STOP
