MANUAL OPERATION B-37
8-1
Conditions for Indexing the Turret Head
To index the turret head manually, the conditions that allow turret head indexing must be satisfied.
If the turret head cannot be indexed although the correct operation sequence is followed, check if
the following conditions are all satisfied.
<Conditions>
1.
The front door is closed.
For details, refer to "DOOR INTERLOCK FUNCTION".
2.
The PANEL key-switch is placed in one of the positions indicated below.
(ON)
(PANEL/EDIT)
3.
A manual mode (handle, jog, rapid traverse, zero return) is selected.
4.
The status indicator
[MRDY]
is lit.
5.
Turret head indexing has been completed normally.
(The status indicator
[TRCL]
is lit.)
6.
The machine is not in the reset state.
7.
There is no turret related alarm.
8.
The machine is not in the synchronized tapping operation (M type).
9.
The zero point of the turret indexing servomotor is established.
10.
The tailstock body is clamped (tailstock specification).
11.
The zero point of the rotary tool spindle drive servomotor is established (M type).
12.
The loader arm is not being extended into the machine (loader specification).
13.
The turret is in the rotation permitted range.
