P-28 DOOR INTERLOCK FUNCTION
5-2-2
Interlock When the Automatic Door is Opened (Automatic Door Type)
The door cannot be opened even when the automatic door open switch is pressed under the
following status.
1.
While the spindle (rotary tool)* is rotating
2.
During automatic operation
3.
During turret head indexing
4.
While the spindle mode is being changed to the C-axis*
*
M/MC specifications
5-2-3
Releasing the Door Interlock Function (Automatic Door Type)
If it becomes necessary to carry out a work with the door opened after releasing the door interlock
function, follow the steps indicated below.
1)
Open the door by executing M85 (door open
command) or by pressing the AUTOMATIC DOOR
OPEN switch.
This door opening operation is not necessary if
the program has been ended after the execution
of M85.
2)
Place the DOOR INTERLOCK key-switch in the
RELEASE
position.
3)
Set the single block function ON for executing an
automatic operation to check the program or carry
out test cutting.
4)
Carry out necessary work.
If the DOOR INTERLOCK key-switch is placed in
the
NORMAL
position while carrying out operation
in the door interlock released state, all machine
operations stop.
NOTE
NOTE
DOOR INTERLOCK
NORMAL
RELEASE
NOTE
