A-12 OPERATION PANELS
4-2-4
Emergency Stop Button [EMERGENCY STOP]
The EMERGENCY STOP button is used to stop the
machine immediately, for example when an emergency
requiring an immediate machine stop occurs.
This button is also used to turn off the power supply on
ending operation.
When the EMERGENCY STOP button is pressed, the power supply to the circuits that control the
axis movements and spindle rotation is shut off and the machine stops.
To reset the emergency stop state, pull out the EMERGENCY STOP button from the pushed and
locked position then press the NC power switch
(ON).
Depending on the machine model and specifications, there may be an EMERGENCY
STOP button at more than one location.
In this case, all of these EMERGENCY STOP buttons have the same function and
pressing any one of them stops the machine. To reset the emergency stop state, it is
necessary to pull out all the EMERGENCY STOP buttons from the pushed and locked
position.
WARNING
The EMERGENCY STOP buttons are used to stop all operations in the
event of an emergency. Memorize the locations of the EMERGENCY STOP
buttons so that you can press one immediately from any location and at
any time while operating the machine. If there is an obstruction
preventing operation of an EMERGENCY STOP button it will not be
possible to press it immediately when an emergency occurs and this
could cause accidents involving serious injuries or damage to the
machine.
NOTE
