ZX Fire Alarm Control Panels
MORLEY-IAS
Installation Manual
Document No. 996-174-000-1, Revision: 01
Page 1
1 Introduction
1.1 Notice
The material and instructions covered in this manual have been carefully checked for accuracy
and are presumed to be correct. However, the manufacturer assumes no responsibility for
inaccuracies and reserves the right to modify and revise this document without notice.
These instructions cover the installation of the Fire Alarm
Control Panels. Refer to the User Manual (P/N 996-182-000-X)
for details of how to operate the system and refer to the
Commissioning Manual (P/N 996-175-000-X) for information on
programming and Level 3 functions.
For use with software
version 834 onwards
The ZX1Se, ZX2Se, ZX5Se and ZX10Se Fire Alarm Control Panels are 1, 1-2, 1-5 and 1-10 loop
panels for use with analogue addressable devices from the following detector manufacturer ranges:
S90
Apollo
Hochiki
Morley-IAS
Nittan
System Sensor
1.2 Warnings and Cautions
These instructions contain procedures to follow in order to avoid injury and damage to
equipment. It is assumed that the user of this manual is a suitably trained installer who is
familiar with the relevant regulations.
Electro-static Sensitive Devices.
Take suitable ESD precautions when removing or installing printed circuit boards.
This panel is CE Marked to show that it conforms to the requirements of the following
European Community Directives:
Electromagnetic Compatibility Directive 89/336/EEC (and the amending directive
92/23/EEC)
Low Voltage Directive 73/23/EEC
This symbol identifies that the Panel uses a safety isolating mains transformer.
Summary of Contents for FW9003 Range
Page 55: ......
