MORNINGSTAR CORPORATION
7
1.0
Installation Safety Precautions
WARNING:
This unit is not provided with a GFDI device. This
charge controller must be used with an external
GFDI device as required by the Article 690 of
the National Electrical Code for the installation
location.
•
Mount the SunSaver-MPPT indoors. Prevent exposure to the
elements and do not allow water to enter the controller.
•
Install the SunSaver in a location that prevents casual contact.
The SunSaver heatsink can become very hot during operation.
•
Use insulated tools when working with batteries.
•
Avoid wearing jewelry during installation.
•
The battery bank must be comprised of batteries of same type,
make, and age.
•
Do not smoke in the vicinity of the battery bank.
•
Mount the controller at least 3 ft (1 m) away from vented bat-
teries unless separated by a barrier or located in a separate
compartment.
•
Power connections must remain tight to avoid excessive heating
from a loose connection.
•
Use properly sized conductors and circuit interrupters.
•
This charge controller is to be connected to DC circuits only.
These DC connections are identified by the symbol below.
Direct Current Symbol
