2-8
2.2 METERS AND LAMPS ON MONITOR PANEL
[1] ENGINE WATER TEMPERATURE GAUGE
This indicates the temperature of the engine cooling water.
During operation, the indicator point s should be in the green range.
If the indicator point s is red range, run the engine at low speed and wait for the
indicator point s to go down to the green range.
★
After stopping the engine, check for leakage of water from the radiator, and
clogging of the radiator core.
Check also that the fan belt tension and check damage to the fan belt.
[2] FUEL GAUGE
This indicates the amount of fuel remaining in the fuel tank.
When the starting switch is at the ON position, if the indicator points to the E,
there is little fuel remaining, so fill the tank.
Make it a rule to fill the tank (to the point where the indicator points to F when
completing the work at the end of each day.
[3] PARKING BRAKE LAMP
This shows the operation of the parking brake.
If the parking brake switch is set to the ON (STOP) position when the engine is
running, the lamp lights up.
If the parking brake switch is set to the OFF (RUN) position when the engine is
running, the lamp goes out.
[4] HIGH-SPEED TRAVEL PILOT LAMP
This lights up to inform the operator that the machine is in the high speed travel
range.
When the Hi-Lo speed range selector switch is set to the HIGH SPEED, the
lamp lights up.
When the Hi-Lo speed range selector switch is set to the LOW SPEED, the
lamp goes out.
[5] BATTERY CHARGE LAMP
This shows the condition of the charging system.
It lights up when the starting switch is turned ON, and when the engine is
started and the speed rises, it should go out.
If it lights up during operations, there is an abnormality in the charging system.
Stop the engine immediately and check for the problem.
Check the alternator and fan belt tension.
If the inspection shows that there is no abnormality, please contact your
distributor.
Summary of Contents for MST-800VD
