7
For details of other Morphy Richards products, please see our website:
QUICK START GUIDE
1
Unpack the product and remove any
additional packing materials as required.
2
Place the product onto a level surface or
ironing board stand.
3
Make sure the anti-scale drawer
‰
is fully
closed.
4
Using the beaker provided
Á
or suitable
measuring jug, fill the water tank
fl
to the full
mark.
5
Set the iron control knob to 3-dot.
6
Connect the unit to the power supply, the LCD
display screen illuminates for 1 second, a short
beep is heard, then the LCD display screen will
turn off. The product is now in STANDBY mode
and the STANDBY ICON will be displayed in the
corner of the LCD display screen
A
.
7
Press the POWER STANDBY button on the
control panel and the unit will heat to the
working temperature, the LOW STEAM ICON
will flash whilst the heating cycle takes place
and will remain illuminated when the boiler is
ready to deliver steam
B
.
Note: At this time, the pump will fill the boiler
with water. You will hear the pump operating,
this is quite normal and will last for
approximately 25 seconds.
8
Press the steam trigger
⁄
to deliver steam to
the iron. Releasing the trigger will extinguish
steam.
9
When ironing is complete, press the POWER
STANDBY button on the control panel to end
the session. The LCD icons will dim until the
unit is disconnected from the mains supply,
only then will the LCD switch off.
10
Allow the unit to cool, drain the water tank
(see page 10), then store away.
AUTO STANDBY DEVICE
(SAFETY FEATURE)
If the unit is not operated for approximately 15
minutes, it will revert to STANDBY mode and the
POWER STANDBY ICON will flash in the LCD
display screen
C
. To re-activate the unit, press
the POWER STANDBY button or the steam
trigger
⁄
and the unit will revert back to the
previous setting.
fl
„
⁄
‰
Á
400ml
‡
·
A
C
B
RN42236MUK Rev2_Instruction Book 25/10/2010 11:38 Page 7