4
Components of your
steam station
⁄
Steam on/off button
¤
Filling cap
‹
Removable anti-scale
cartridge
›
Anti-scale release button
fi
Water tank
fl
Power cord
‡
Temperature dial with indicator
·
Temperature indicator light
‚
Supply cord
„
Steam on/off indicator light
‰
Filling funnel
Before use
Note: The steam facility should only be
used on garments which are suitable for
ironing at the 3 dot setting.
Clothes can be steam ironed at the 2 dot
setting, but only for a short period.
Textiles and clothes are supposed to
carry ironing instructions. If they don’t you
should follow the fabric guide on page 3, but
be sure to test the temperature by ironing the
hem of the garment or similar area first.
If you turn the control dial down from a
hot setting to a cooler setting, wait until the
steam station temperature has stabilised
before you continue ironing.
Filling
1
Make sure that the steam station is not
plugged in before filling the tank with
water.
2
Lift up the fill cap
¤
and fill the tank
fi
with water through the filling hole using
the funnel provided.
A
1.1 litres fills the
tank. After filling replace the fill cap. In
hard water areas the use of distilled or
demineralised water is recommended.
WARNING: Never use battery topping
up fluid or water containing any
substances like starch, or sugar, or
defrosted water from a refrigerator.
3
Always pour out the remaining water if the
product is not to be used for a few
weeks. Water can be left in the unit
between normal ironing periods.
WARNING: When filling your steam
station with tap water always use the
funnel provided. Never fill directly under
the tap.
Temperature control
Plug in the steam station and switch on.
Set the temperature control dial on the iron
B
to the temperature required, but don’t
start ironing immediately.
⁄
¤
‹
›
fi
fl
‡
·
‚
B
A
„
‰
42345 Rev 2 31/5/05 9:39 AM Page 4
