Using
Filling the kettle
1
Wherever possible fill through the spout,
as this helps to free the filter from
limescale build-up.
• The integrated water level indicator
allows you to easily see the amount of
water in the kettle.
• Always ensure that the level of water in
the kettle is filled to at least the minimum
level shown on the water gauge. Should
your kettle not have a water gauge,
always ensure that the element is
covered.
• Boil only as much water as you need as
this saves electricity.
2
Place the kettle on the base unit,
ensuring the kettle locates on to the
360˚ connector.
• The 360˚ connector allows the kettle to
be located at any position. - ideal for left
and right handed users and for
convenient positioning on worktop.
3
Plug in and switch on at the wall socket.
4
Switch the kettle on. The ‘power on’
neon, inside the water level indicator will
light up.
5
When the water boils the kettle will
switch off automatically.
• If you are using the kettle for the first
time, pour away the boiled water and
refill.
6
Lift the kettle from the base unit by the
handle ensuring you hold the kettle level.
• To re-boil, switch to ON again. If the
kettle has just switched off wait a minute
or so before switching it back on again.
• If you do not put in enough water, or
switch on the kettle when it is empty, the
safety cut-out will switch off the power
automatically. If this happens, refill and
wait a few minutes for the element to
cool, then use as normal.
Filter removal
1
Open the lid.
2
Press down on the filter tab to unclip.
3
Lift the filter upwards to remove.
4
To refit the filter, slot the lower hook in
the bottom of the recess and click top
tab firmly into place. Ensure the filter is
correctly located.
WARNING: Unless the filter is fitted
correctly, the kettle may not switch off
after boiling.
4
