5
Turn the Control Dial
(16)
to the first position to
start. Increase speed as required.
3
Place your ingredients into the Mixing Bowl
(12)
.
Always place wet ingredients in the Mixing Bowl
first followed by dry unless stated in the recipe.
Place the Bowl Cover
(2)
, with the Inlet Cover
(1)
in place, onto the Mixing Bowl
(12)
, ensuring they
are securely in place.
Lower the desired Accessory onto the Drive
Shaft. Gently twist anti-clockwise to engage.
1
Place the Motor Housing onto a dry stable, surface.
Ensure the Drive Shaft is fitted in the Mixing Bowl
and lower the Mixing Bowl onto the Motor Housing,
ensuring the Mixing Bowl is properly seated (see
‘Mixing Bowl Setup’ section on page 7).
Twist and lift the accessory from the Drive Shaft.
The Mixing Bowl should just lift off, but if not
twist slightly anti-clockwise and lift to remove.
Do not twist too much as this will unlock the
Drive Shaft, ensure the Drive Shaft is correctly
fitted and locked before next use (see page 7).
5
When finished, turn your Mixstar Mixer off
and remove the Bowl Cover and Inlet Cover.
Using Your Mixstar Mixer
It is important to clean your Mixstar Mixer before first use or if it has not been used for a long period of time.
Clean all parts, excluding the Motor Housing
(14)
in warm soapy water. Dry thoroughly.
Before First Use
2
4
00:01
6
FP400520 MUK Rev1.qxp_Layout 1 14/05/2020 16:45 Page 5
