Morris B7556CAP, Operating Instructions Manual

3

Installation Instructions

Suitable Installation Place

Solid and level 

fl

oor

• Unstable installation causes vibration and noise of 

refrigerator.

• Wooden 

fl

oor or carpet can be discolored under the 

refrigerator.

• Doors look hanged down due to the twist of 

refrigerator unless it is leveled.

Shady and humid place

• Direct sun rays, side heat of stove and gas range can 

weaken the refrigerating power.

• Avoid location by a sink or where moisture and water 

can cause rust and corrosion.

• Avoid location where moisture can cause electrical 

problems.   

• Use hard board or plank on the concrete/cement 

fl

oor.

Installation of the Appliance

The space required for installing the appliance is 
shown below. (unit: mm)

• More than 10cm from 3 sides(lieft, right, and back) is 

good enough for ventilation.

• Insuf

fi

cient space causes the noise of vibration, 

weakening of refrigerating power and the waste of 
electricity.

Grounding

Grounding terminal is the green one connected to the 
power cord in the back of refrigerator.

Grounding is necessary at

the place where water splashes easily;
humid basement;
any wet or watery place.

Grounding with grounding wire

Copper plate connected with ground wire is to be buried
25cm deep in the ground.

Grounding with short-circuit breaker

Short-circuit breaker is necessary in wet 

fl

oor like 

fi

sh

shop, kitchen of restaurant and etc...

Grounding is not necessary

in case of using side-grounded outlet.

Don’t connect the ground wire to

water pipe, gas pipe, telephone line or lightening-rod due
to the possibility of explosion or 

fi

re.

Correct usage of Refrigerator

Plug in the refrigerator right after installation.

• Once the refregerator is plugged in, make sure the 

interior light comes on when you open the doors.

Set the temperature of both compartment to “MAX” to
conduct the preparatory run for 2 or 3 hours.
Once inside of refrigerator is cooled enough, then
put the food in the refrigerator.

*  

When ambient temperature is high in midsummer, 
do not open and shut the doors frequently after 
installation.

Installation of height adjustment feet for 
leveling

Level refrigerator to rest solidly on the 

fl

oor.

There are two leveling feets under each front corner 
of refrigerator.
Turn leveling feet clockwise to raise the refrigerator 
and turn it counter-clockwise to lower.
Use shims under the rear corners if necessary.

• If you want the door of refrigerator to be closed 

smoothly and not to be open easily, adjust the front 
feets to be raised horizontally.

932

Wall

100

100

100

125°

595

15.3

1216

1129

575

ulvT}G⯜⫠㏘G㤸㟝O㜵PU•‹‹GGGZ

YWX]TW^TW]GGG㝘䟸GXa\]aY^