7
2.
After the 5 seconds , the timer indicator light
will light up continuous , no longer flashing ,
meaning the setting is successful.
Note : Each mode can choose the time setting ,
when the setting time is finished , the compressor
will shut down , the fan will stop running , entering
into the standby mode .
Anion function
1.
Press the “anion”button , start the anion
function ; If no needs of the anion function , press
the “anion”button again
Attention:
This machine is B type low temperature
dehumifier , its using environment temperature is
5-35 °C . If the indoor temperature is too low , the
cooler’s surface will be frosted , then the
defrosting function will start automatically , the
power light will be flashed at this time .
If the low temperature happens , the defroster will
close the dehumidifier automatically, enen
pressing the “humidity”setting , the
dehumidifier will not start . When the defroster is
detecting the appropriate operation temperature ,
the compressor will be restarted .
Attention:
1.
If the setting humidity is higher than actual
environment humidity , the dehumidifier will
not operate .
2.
When the full water light is light up , please
pour out the water in the tank , and then put
back the water bank , the machine will
continue to operate.
3.
When the machine is shut down , please
restart after waiting for 5 minutes , in order to
ensure the compressor’s using life longer .
4.
If do not use the dehumidifier for long time ,
please pull out the power cord’s plug .
water draining introduction
WARNING
illness risk
Do not drink the collected water in bucket.
Otherwise it may lead to illness.
Take out and put back the water tank.
1.
When the water tank is full of water , the
machine will stop running , the full water
indicator light will light up .
2.
Before pouring out the water , please make
sure to pull out the power plug .
