OPERATION
Menu / user programs
Select user programmes menu and touch
. 10 fully customisable user programmes
are available.
Operating user programmes
Using
navigation sensor fields, select
a user program such as P0 and touch , to
confirm your selection. The appliance display
will show the default settings for all P0-P10
user programmes, which are the same as
those shown below: conventional cooking,
temperature 180°C and cook time 00:30.
If no changes are made within 3 minutes, the
appliance switches to standby mode.
Place food in the open, close the door and
touch . sensor field to start the programme.
The programme is started. In box 2 of the pre-
set programme COOK TIME changes to END
TIME and consequently cook time of 0:30 is
replaced with end time and the remaining time
is shown on the progress bar.
Once the programmed cook time has
elapsed, all functions except cooling fan are
turned off (see: Cooling fan operation) and an
acoustic signal is sounded (4 beeps / pause
/ 4 beeps).
The sequence is repeated every 3 seconds
for about 5 minutes. The display shows the
temperature set for the oven chamber and
END TIME and symbol is flashing.
Touch ,to acknowledge and mute the
acoustic signal. After this, the appliance
switches to standby mode.
Editing user programme settings
To modify the heating function and COOK
TIME, touch and hold sensor field and then
touch . sensor field. Function name and
symbol start flashing in box 3.If no changes
are made within 3 minutes, the appliance
exits to upper menu (User Programmes) and
stores settings last shown on the display.
Only changes confirmed by touching are
updated.
Touch
. navigation sensor fields to
change the heating function. Available heat-
ing functions are described in section Menu
\ Heating functions.
Select the desired function and touch .
sensor field to confirm. After touching the
sensor field, heating function symbol and
name stop flashing in box 3. At the same time
symbol start flashing and it is possible to
modify the temperature. If no changes are
made within 3 minutes, the appliance exits
to upper menu (User Programmes) and
stores settings last shown on the display.
Only changes confirmed by touching are
updated.
29
Summary of Contents for MOF-64510
