8
How to use
[Starting up]
Turn power switch to “I” marked position, then press on-off key on the control panel to start up the machine. After starting
up, the machine runs on the mode of last power off.
Key
Function Description
On-off key
On the idle mode, press on-off key to enter the power-on mode, the warmer starts working and
the whole machine runs under the previous remembered mode and temperature. On the
power-on mode, press on-off key to enter the idle mode, the warmer stops working. (Note: On
the heating mode, draught fan will operate for 15 seconds at low wind speed after power off.)
Mode key
After power-on, the warmer is in the intelligent mode by default. Repeatedly press the “mode
key”, the warmer shifts in circular order among “intelligent mode, low warm wind, high warm
wind, strong warm wind, breeze, and gentle breeze”.
(+) / (-) key
On the working state, press “+” or “-” keys to set the working temperature. The temperature
setting range is 5
℃
~35
℃
and every temperature value is of 1
℃
difference. The machine
confirms and displays the set temperature value if no key is pressed within 3 seconds after the
setting. After room temperature reaches the set temperature, display screen blinks for 10
seconds and heating unit stops working. When room temperature is below the set temperature,
machine restarts to heat.
Ιn warm wind modes (low/
high/strong), w
hen setting temperature is
higher than 35
℃
or lower than 5
℃
the panel will display “--” and the machine will
continuously working at “without temp. control” mode, no matter which the current room
temperature is.
Timing key
In power-on mode, press this key to set timing power-off function. The display flashes the
remaining time which was set last time. The power-off timer can be set by pressing the "+" and
"-" buttons. The setting range is 0 to 24 hours. If there is no operation after 5 seconds, the
machine confirms the set time and start counting down. If the set time is 0, it means cancel the
timing power-off function. If the set time is not 0, when the set time is reached, the machine
will automatically shut down and enter standby mode.
In standby mode, press this key to set timing power-on, same operation as timing shutdown.
The unit of timer setting is hours.
Sway key
In the power-on mode, press this key to start swaying, and press again to stop swaying.
“-”key
Timing key
Sway key
“+”key
On-off key
Mode key
Display screen
