Morris W7448SDL, User Manual

damaged appliance. Inform your retailer or point of sale of any damage. In such a case, 
keep the packaging.

•

It is recommended that the appliance be allowed to settle for at least 4 hours before

connecting the electrical power supply, so that the compressor fluid feed is correct.

•

Proper  air  circulation  is  necessary  to  avoid  overheating.  To  ensure  sufficient

ventilation, observe the installation recommendations provided.

•

In order to avoid fire risk, wherever possible, ensure that the appliance is not in

contact  with  walls  or  with  any  hot  element  (compressor,  condenser).  Observe  the 
installation recommendations.

•

The appliance should not be placed close to radiators or cooking hot plates or gas

rings

.

•

Check that electrical sockets remain accessible when the appliance is installed.

POWER SAVING

To limit the electricity consumption of your appliance:

• Install it in an appropriate place (see “Installing your appliance”).
• Leave the doors open as little time as possible.
• Do not put food that is still hot into the appliance.
•To ensure that the appliance operates properly, clean the condenser regularly 

(see

“Routine servicing of your appliance”). 
• Regularly inspect the door seals and ensure that they are still closing properly. If this

is not the case, contact your after-sales service.

Trouble shooting

•

Any electrical work should be carried out by a qualified and skilled

technician.

•

The  appliance  should  be  repaired  by  an  accredited  repair  centre,  using  only

manufacturer’s original spare parts.

The appliance is designed for home use only. The manufacturer declines any liability 
whatsoever in the case of another utilisation.

  R600A 

  Safety instructions

Caution: Do not obstruct the ventilation 

grills on the appliance.

Caution: Do not store explosive

VXEVWDQFHVVXFKDVDHURVROFDQV
FRQWDLQLQJDQLQIODPPDEOHSURSHOODQW LQ
WKHDSSOLDQFH

Caution: Do not damage the refrigerating 
circuit in the appliance.

Caution: The refrigerating units use
isobutane (R600a), and should not be placed
close to ignition sources (for example, 
electrical contacts that are exposed or open 
contacts that could be closed by the
refrigerating fluid in the event of a leak). The 
refrigerating fluid type is specified on the 
power cabinet identification plate.

Caution: Do not use electrical equipment
in the compartments of the appliance, 
unless they are of the type recommended
by the manufacturer. 

This appliance meets the requirements of all applicable European directives and their amendments.