The Specialist In Drum Handling Equipment
Model 405-114
Omni-Lift Karrier
Operator’s Manual for Morse Omni-Lift Karrier Model 405-114
Serial Number 0617 to ____ (MMYY)
morsedrum.com
Copyright 2019 - Morse Mfg. Co., Inc.
Form OM405-114 (0617-____)
(Updated June 12, 2019 3:30 PM)
5
3. Raise the horizontal drum from the rack a few inches and back the Omni-LIft away.
4. Lower the horizontal drum to about 48” (122 cm) from the floor.
To lower the drum with the power lift, lower the control valve.
5. Secure drum BEFORE tilting by operating ratchet to tighten strap around drum. Ensure that the chine catches are immediately under
the top rim of the drum..
6. Carefully tilt the drum to the vertical position.
7. Lower the upright drum to the floor.
8. Release upright drum: When the weight of the drum is entirely on the floor, squeeze the ratchet release lever and open all the way
to unlock. Then release the tension on the strap. Allow enough slack in the strap in order to remove strap loop from clevis. Swing
both hinged bands to the open position.
9. Raise the drum holder assembly about 12” (30 cm).
10. Pull the Omni-LIft back to clear the drum.
11. Store unit with drum holder assembly in the horizontal position and lowered near the floor.
Maintenance
Periodic inspection for the general condition of structural and mechanical components is imperative for safe and ef-
•
ficient operation.
Periodically inspect all moving parts, framework, and contact areas for signs of wear, fatigue, or loosening. Tighten,
•
adjust, or replace parts as necessary to prevent failure and maintain proper function.
Inspect the hydraulic system for oil drips, hose damage, or other signs of wear. Inspect the level and condition of the
•
hydraulic fluid. Replace any parts that show signs of wear.
grease wheel bearings periodically. Oil or grease all moving parts including: the three clevis pins and the surfaces
•
of the boom which contact the inside of the mast cap, the hinge pin, the gears and sprockets in the tilt drive, and the
ratchet and pawl.
Worn or damaged parts must be properly replaced with the correct, genuine Morse parts.
•
Hydraulic pump is shipped filled with Noco Premium plus automatic transmission fluid d/m. Material safety data sheet
•
(msds) is available online. Change oil yearly, sooner depending on dirty conditions or outdoor use.
Replace oil with
Mobil dte 24 or equivalent for indoor use (Mobil dte 13 for outdoor use).
Parts Information
Worn or damaged parts must be properly replaced with the correct, genuine Morse parts.
