7
See figure 8.
If the fir
If the fir
If the fir
If the fir
If the fire is tur
e is tur
e is tur
e is tur
e is turned of
ned of
ned of
ned of
ned off or the flames go out, wait at least 3 minutes
f or the flames go out, wait at least 3 minutes
f or the flames go out, wait at least 3 minutes
f or the flames go out, wait at least 3 minutes
f or the flames go out, wait at least 3 minutes
befor
befor
befor
befor
before attempting to r
e attempting to r
e attempting to r
e attempting to r
e attempting to relight. A safety device in the contr
elight. A safety device in the contr
elight. A safety device in the contr
elight. A safety device in the contr
elight. A safety device in the control stops the
ol stops the
ol stops the
ol stops the
ol stops the
fir
fir
fir
fir
fire being tur
e being tur
e being tur
e being tur
e being turned back on until it is safe.
ned back on until it is safe.
ned back on until it is safe.
ned back on until it is safe.
ned back on until it is safe.
-
Turn the left hand control knob fully clockwise.
-
Push in the right control knob and, while keeping it depressed, turn
anticlockwise through the ignition position marked and up to the
pilot position marked . The spark should light the pilot.
-
If the pilot does not ignite, keep the knob depressed for a few seconds
to purge air from the supply pipes. Then turn back to the off position
marked
•
and repeat the ignition procedure.
-
When the pilot has lit, keep the right hand control knob depressed for a
few seconds to allow the pilot flame to stabilise then release it. If the
pilot does not remain alight ensure that the air has been purged.
-
Partially depress the right control knob and turn to the main burner
position marked . The main burner should now light at its low position.
-
The left-hand knob is for burner flame adjustment. Turning it
anticlockwise should gradually increase the flame height.
-
The flame height control does not have to be re-set every time the fire
is lit. It can be kept at any position enabling the customer to use the
right hand control only to ignite the burner at the set flame height.
-
After checking turn the right hand knob to off. Depress the control knob
partially at the pilot position ( ), turn clockwise to off (
•
) and release
the knob. If any resistance is felt when turning, release the downwards
pressure on the knob before continuing to turn.
CHECK FULL OPERA
CHECK FULL OPERA
CHECK FULL OPERA
CHECK FULL OPERA
CHECK FULL OPERATING SEQUENCE
TING SEQUENCE
TING SEQUENCE
TING SEQUENCE
TING SEQUENCE
Figur
Figur
Figur
Figur
Figure 6
e 6
e 6
e 6
e 6
Figur
Figur
Figur
Figur
Figure 7
e 7
e 7
e 7
e 7
