Morso 5660 Standard Insert, Instructions For Installation And Use Manual

1

DK ENG

1.1 Unpacking the stove

We recommend that two persons perform this task since the stove is too heavy to handle sin-
gle-handedly. MORSØ 5660 weighs approximately 15 kg.

The stove is suited for intermittent use.

1.2 Installing the stove

National  and  local  regulations  regarding  the  installation  of  wood-burning  stoves  must  be 
 observed, as must local regulations regarding chimney connections and chimney installation. 
You may want to ask your chimney sweep for advice. However, you, your technical adviser or 
workman are responsible for complying with the applicable national and local regulations.

1.3 Chimney sweep

As  stated,  it  may  be  wise  to  consult  your  local  chimney  sweep  before  installing  the  stove. 
In  any  event,  the  chimney  sweep  must  be  notified  once  the  wood-burning  stove  has  been 
 installed.  The  chimney  sweep  will  inspect  the  installation  and  schedule  sweeping  intervals 
with you. If your chimney has not been used for some time, it should be inspected for cracks, 
bird nests, etc., before it is used.

1.4 location of the stove/distance requirements

The requirements to the placement of the stove and the separation requirements depend on 
the environment in which the stove is placed:

A. 

Built into masonry or an existing fireplace opening

B. 

Custom-built fireplace structure in flammable surroundings

A. Built into masonry or an existing fireplace opening
The insert is primarily designed to be built into masonry or an existing fireplace opening.
The adjacent materials must be nonflammable.
A layer of wallpaper is normally considered nonflammable when applied to masonry.
A nonflammable floor protection must cover the floor at least 00 mm to the front of the firing 
door and at least 150 mm to each side of the firing opening.
Please note that the floor must be capable of supporting the installation.

There are only spacing requirements when the stove is placed next to flammable materials.
The spacing requirements are the following:

Distance to furniture 

100 mm.

*Right-angled distance to flammable sidewall 

00 mm. 

** Height over flammable floor 

00 mm.

1.0 Installing your Morsø stove