OPERATING THE TREADMILL
27
Operating the Treadmill
1.
If the limited access switch is on, place the magnet over the logo on the controller. Attach the cord of the
magnet to the patient's wrist or belt, if desired.
2.
Press the
Power
key. The controller performs a self test. If the self test is satisfactory, the
Enter Wt
indicator
flashes and the controller displays the default values:
Grade:
Current grade in %
Weight:
150 lb. or 68 kg (user selectable)
Speed: 0.0
If the controller finds a fault in the system during activation or during exercise, it displays an error code
(example: E202). If an error code appears, press
Power
twice to restart the system. If the error code appears
again, record the code number, then turn off the treadmill and call Mortara Technical Support (see Maintenance/
Troubleshooting, Chapter 3).
3.
Change the units (optional). To change from English units to metric units and vice versa, press the
Units
key.
You can change the units at any time.
4. Enter weight (optional). To enter the patient's weight, press the
+
or
-
keys until the correct value is in the
display, then press the
Select
key for the system to accept the new value.
minimum entry:
30 lbs (13 kg)
maximum entry:
400 lbs (181 kg)
To use the default weight (150 lb/68 kg), press
Select
.
4.
Enter time (optional). Enter the exercise time by pressing the
+
or
-
keys until the correct value is in the display,
then press
Select
to enter the new value. You can choose one-minute increments only. For example: for a 10-
minute exercise, enter 10:00 when the Enter Time LED is flashing.
minimum entry:
01:00
maximum entry:
96:00 (or max time limit if activated).
If you do not start the walking belt within five minutes after entering values, the controller
automatically resets the entries to default values.
5.
Press
Start Belt
. The belt accelerates gradually to minimum speed and remains at minimum until you press
Faster
.
6.
Have the patient step onto the treadmill per the guidelines.
7.
Press
Faster
or
Slower
to increase or decrease the walking belt speed. The display shows the target speed as it
adjusts to the change. You can change the speed at any time during the exercise.
8.
Press
Up
or
Down
to increase or decrease the grade. The display shows the target grade as it adjusts to the
change. You can change the grade at any time during the exercise.
9.
Press
Select
to choose a particular exercise display (Time, Distance, Pace, Calories, Caloric Rate, METS,
Scan). The displays change sequentially each time you press
Select
. To rotate continuously through all
displays, select
Scan
. Each display will appear for three seconds per cycle.
Summary of Contents for Quinton CR60
