USE AS A WELDER
DSP
M
32
© MOSA
1.0-04/02
Access to non qualified personnel is prohibited
in proximity of these areas:
- the control panel (front-end) - the engine exhaust
fumes - the welding process.
ATTENTION
PUSH AND
TWIST
This symbol (regulation EN 60974-1 on safety
requirements for arc welding apparatus)
indicates that the engine driven welder is
suitable for use in environments with an
increased risk of electrical shock.
WELDING CABLE CONNECTION
Fully insert the welding cable plugs into the
corresponding sockets turning them clockwise to
lock them in position.
☞
Make sure that the ground clamp, whose cable
must be connected to the + or - terminal,
depending on the type of electrode, makes a
good connection and is near to the welding
posítion.
Pay attention to the two polarities of the welding
circuit, which must not come in electric contact
between themselves.
21/04/04 M32_DSP_GB
