RC1 REMOTE CONTROL
DSP
M
38.9
© MOSA
1.0-04/02
09/04/02 M38GB
When the RC1 is not used, it is necessary to disconnect
the multipole connector
ATTENTION
Is it possible to connect the RC1, to all
DSP
engine driven
welders
.
The remote control RC1, which regulates the welding current
in the CC mode and the welding voltage in the CV mode, is
connected to the front panel by means of a multipole connector.
When the remote control is connected to the remote control
connector (8), it is functional and automatically excludes the
front panel regulation. The remote control can also be
connected to the connector on the wire feeder front panel but
in this case it is necessary to switch the wire feeder commutator
so it can operate.
The polarity inverter (64A), if installed, can be operated from
the remote control.
Adjust the welding current control knob to the correct current
for the diameter and type of electrode being welded.
PUSH AND
SCREW TIGHT
