3
6. Never drop or insert any object into any opening.
7. Take care when using outside, make sure appliance
remains dry at all times.
8. Do not use this appliance with a damaged or broken
comb or blade set, as this could cause an injury to the
animal.
9. Do not place or leave appliance where it may be
damaged by an animal or exposed to weather.
10. To disconnect, turn all controls to ‘off’ then remove plug
from outlet.
DIRECTIONS FOR USE:
1. Turn unit on/off
Turn variable speed switch in clockwise direction to
turn unit on or increase speed.
To turn unit off and reduce speed, turn switch anti-
clockwise until hearing a click. (fig.1)
2. Remove/replace blade
The clipper should be switched off before removing
blades. Remove blade (fig.2). The cutting head can
be removed by pressing the button under the blade
and pushing the blade away from the housing.
To refit the blade set, the clipper should be turned on
and running. Fit the blade into the metal guide and
press it into place. There will be a definite click when
the blade is snapped in place.
3. Remove/replace drive tip (see step 2)
Remove the drive tip by grasping with the drive tip
removal tool and pulling. (fig.3a) Install by aligning the
lower end of drive finger and pushing until drive tip
snaps into position. (fig.3b) (Don’t use pliers to replace
tip, as this may damage the part.)
4. Remove/replace hinge (see step 2)
Remove two screws. Lift hinge assembly from unit
(fig.4)
5. Remove/replace cam follower (see step 2 and 4
Remove screw. (fig.5a) Remove front cover. (fig5a).
Front cover is removed by rolling the part off from the
bottom. The front cover is installed by pushing straight
onto the clipper. Remove mechanism cover by grasping
tab and pulling straight up. (fig.5b) Cam follower (fig.5c)
is removed by grasping tab and pulling straight up,
using needle nose pliers. (fig.5d). Install by aligning as
shown in fig.5d and push down to snap into location.
