4
- Some countries do not allow the exclusion or limitation of
incidental or consequential damages or exclusions of
implied warranties. Therefore, the limitations or exclusions
herein may not apply. This warranty gives you specific legal
rights, in addition to other rights which vary from state to
state or country to country.
Make sure that the device is not plugged into the mains
before making any connections. It is also recommended to
turn off or disconnect all other devices associated while
making connections to the product.
Connect your RCA cable (Sub output of your hi-fi amplifier
or A/V) on the dedicated subwoofer input: "SUB IN"
⑤
.
Check that you have positioned the voltage selector to suit
your Country:
⑦
.
INPUT VOLTAGE: AC110 (USA) and AC230 (EUROPE).
Plug the AC power cord (one hand connector AC Mains
product then the other) to a wall outlet.
Turn the POWER switch to "ON".
WARNING:
Be sure to turn off the power switch on your
product before making any connections. Similarly it is best
to cut the power of the other devices you want to connect
to your amplifier.
Connecting the Subwoofer
.
You must use the RCA Subwoofer output (RCA
⑤
) of the
amplifier and connect it to the red RCA input (marked "IN
Low level" and "R / mono" socket on the bottom left).
Warning:
Be sure to turn the volume knob of the
subwoofer at the minimum position before any connection
to the AC power outlet.
After connecting the power cord to the wall power outlet,
set the button
⑧
to "ON". After a few seconds, the "LED"
turns green to indicate that the subwoofer is turned on.
The switch
④
configures the subwoofer in the automatic
mode off, the subwoofer will automatically enter in "sleep"
mode (shut down of internal power circuits) after a period
of inactivity of 5 minutes.
Note:
If the subwoofer has a tendency to pause during a
movie, turn down the volume control on the subwoofer and
then compensate the reduction in sound level by increasing
the level of the subwoofer output of the audio amplifier
video.
① VOLUME
.
Adjust the sound level of the subwoofer to your liking.
② CROSSOVER
.
Adjusts the cutoff frequency of the subwoofer can achieve.
At this point the main speakers take over.
③ PHASE
.
After placing your subwoofer in the room, you have a
setting to adjust the phase. The optimum phase adjustment
is made subjectively, it is the position of the potentiometer
delivering the most bass.
④ STANDBY / ON
.
On the Auto position, the LED emits red light (STAND-BY)
becomes green (ON) when a signal is detected. If the
subwoofer does not receive a signal within 5 minutes, it will
return to stand-by mode and the LED emits a red light
again.
⑤ SUB IN
.
2 RCA connectors allow you to connect your amplifier to
the subwoofer.
⑥ BASS EXTENSION
.
The LEVEL knob adjusts the level of presence of bass in the
frequency range selected by the FREQUENCY button.
In most cases, we will choose to adjust the LEVEL knob to
"0 dB" and FREQUENCY to "STANDARD". The bass level
from the subwoofer is now linear up to the low cutoff
frequency of the subwoofer.
In "IMPACT" position, the subwoofer will be able to deliver
"dry" bass sounds for a more accurate listening at high
levels. (Home Theatre configuration).
In "INFRA" position, the subwoofer will then focus on very
low frequencies. This type of setting is only useful when the
subwoofer is already connected in an audio system
including huge tower speakers providing naturally low
frequency. (Music configuration).
Basic instructions
Quick starting guide
Warranty
Turn on the subwoofer
Connecting the subwoofer
Turn on the subwoofer
Description and connections
