8
Channel
7
8
Return
to Channel 1
Monitor
Controller
Briefly press the
Frequency
Selection
button six times.
Briefly press the
Frequency
Selection
button
six times. The controller will beep
seven times.
Briefly press the
Frequency
Selection
button
seven times. The controller will beep
eight times.
Briefly press the
Frequency
Selection
button
eight times. The controller will beep
once.
Briefly press the
Frequency
Selection
button seven times.
Briefly press the
Frequency
Selection
button eight times.
Or power the monitor and
controller OFF, then ON, to
select Channel 1 again.
Notes:
• Allow 2 to 3 seconds between channel selections.
• If selection is unsuccessful, power both the controller and monitor
OFF
, then
ON.
Before First Flight
Propeller Attachment
Controller
Operation
Screw on the propellers and indicated above,
in the direction of the marked arrowhead.
Once the propeller is attached, seal it with its
protective cap as shown above.
Note: Propellers are matched to a specific motor. Check the placement of the
propellers as shown in the diagram:
A
B
A
Figure
Nose
Tail
B
