• vv
v
3
PUSH
DOWN
SASH
LAP
PULL
OUT
SLACK
CLICK
SELECT
RECLINE
1, 2, 3
quick start guide
Forwar
d-facing installation:
12 months up to 4 years (appr
oximately)
• vvv
2
PUSH
DOWN
PULL
OUT
SLACK
CLICK
quick start guide
Rearward-facing installation:
newborn up to 12 approximately
POSITION 4
• vvv
3
PUSH
DOWN
SASH
LAP
PULL
OUT
SLACK
CLICK
SELECT
RECLINE
1, 2, 3
quick start guide
Forward-facing installation:
12 months up to 4 years (approximately)
• vv
v
3
PUSH
DOWN
SASH
LAP
PULL
OUT
SLACK
CLICK
SELECT
RECLINE
1, 2, 3
quick start guide
Forwar
d-facing installation:
12 months up to 4 years (appr
oximately)
• vvv
12
Child restraints must be used correctly to provide proper protection for your
child. The anchorage system on child restraint must be used in the correct
way.
CORRECT
Make sure there is no slack in the top strap and the attachment clip is upright
in the anchorage fitting.
INCORRECT
The clip must not lie flat on the anchorage fitting.
INSTALLATION
CORRECT
Make sure there is no
slack in the top strap
and the attachment
clip is upright in the
anchorage fitting.
The clip must not
lie flat on the
anchorage fitting.
Anchorages in
vertical panel at
rear of vehicle
Floor mounted
anchorages
INCORRECT
FIGURE 1
FIGURE 2
x
x
convertible car seat
preparing vehicle for your seat
• vvv
13
convertible car seat
preparing vehicle for your seat
Vehicle metal
structure
Spacer(s)
(if required)
Attachment bolt
Anchor fitting
Vehicle trim
1
Centre line of
seating position
200mm
min.
FOR SEDANS ONLY:
2
Vehicle metal
structure
Spacer(s)
(if required)
Attachment bolt
Anchor fitting
Vehicle trim
Lock washer
Nut
Reinforcing
washer
3
FOR CARS FITTED WITH A CHILD
RESTRAINT UPPER ANCHORAGE POINT
Locate the upper anchorage point behind
the rear seating position (consult the car
owner’s handbook for the location of the upper
anchorage point).
Remove the thread plug from the parcel shelf/
floor/roof and install the attachment bolt as
shown in
Figure 1.
CAUTION: DO NOT OVERTIGHTEN THE
ATTACHMENT BOLT. OVERTIGHTENING MAY
FRACTURE OR BREAK BOLT. MAXIMUM
TORQUE IS 20 Nm.
FOR CARS NOT FITTED WITH A CHILD
RESTRAINT UPPER ANCHORAGE POINT
For sedans only
Drill a 9mm diameter hole in the parcel shelf
on the centre-line of the seating position as
shown in
Figure 2. Install the anchor bolt as
shown in
Figure 3. It is recommended that this
installation be carried out by a child restraint
fitting station or licenced motor mechanic.
For vehicles other than sedans
In Australia, consult your nearest child restraint
fitting station or traffic authority for vehicle
inspection to find the best, correct position for
the placement of the upper anchorage point,
and for the correct attachment bolt length and
use of spacers. In New Zealand, consult the
agent for the vehicle.
Summary of Contents for serenity 017340
